TM-9-2320-366-34-1 MTV Direct Maintenance Manual M1083 Series - Volume 1 Download
Page 1349 of 1591
TM 9-2320-366-34-1 D-15. MARKING SLEEVE FABRICATION Fabricate marking sleeves according to the following information. a. Cut from bulk sleeve material 12414663 FP-301-12.7, 2 inches (5.2 cm). b. All dimensions are in inches (centimeters). c. Identify by applying the following applicable numbers to the sleeve according to MIL-STD 130. CAGE CODE PART NUMBER D-16. M1089 30K WINCH TEST ADAPTER Assemble the M1089 30K winch test adapter according to the following steps. Refer to the following parts list and Figure D-26. M1089 30K Winch Test Adapter for details. Part Number Material Description National Stock Number Qty 4-4-4 100401BA Tee, Tube 4730-01-095-3430 1 4-6 100102BA Adapter, Straight, Pipe to Tube 4730-01-096-9398 1 207P-4 Coupling, Pipe 4730-00-881-1161 1 NB-4-035 Tubing, Nonmetallic 4720-01-071-4042 4 in. MIL-T-27730 Tape, Antiseizing 8030-00-889-3534 1 roll Figure D-26. M1089 30K Winch Test Adapter a. All dimensions are in inches (millimeters). b. Cut two pieces of nonmetallic tubing (1 and 2) to 2.0 in. (50.8 mm) long. c. Remove three nuts (3), sleeves (4), and ferrules (5) from tube tee (6). d. Install two nuts (3), sleeves (4), and ferrules (5) on nonmetallic tubing (1). e. Install nonmetallic tubing (1) on tube tee (6). f. Remove nut (7), sleeve (8), and ferrule (9) from straight adapter (10). g. Install two nuts (3 and 7), sleeves (4 and 8), and ferrules (5 and 9) on nonmetallic tubing (2). h. Install nonmetallic tubing (2) on tube tee (6). i. Install nut (9) on straight adapter (10). j. Apply one wrap of antiseizing tape to threads of straight adapter (10). k. Install pipe coupling (11) on straight adapter (10). D-32 Change 1