TM-9-2320-366-34-1 MTV Direct Maintenance Manual M1083 Series - Volume 1 Download
Page 1274 of 1591
TM 9-2320-366-34-1 TM 9-2320-366-34-1 TM 9-2320-366-34-1 TM 9-2320-366-34-1 TM 9-2320-366-34-1 2-1099 2-1099 2-1099 2-1099 2-1099 FOUR WAY CONTROL VALVE ASSEMBLY FLOW TEST NOTE If boom swings right OK but will not swing left: substitute port B for port A, in steps (2), (3), (14) and (15), and operate swing control left, in step (8). (10) Shut down MHC (TM 9-2320-366-10-1). (11) Position MHC power to OFF (TM 9-2320-366-10-1). (12) Position PTO switch to off (TM 9-2320-366-10-1). (13) Shut down engine (TM 9-2320-366-10-1). (14) Disconnect hydraulic tester, hoses and adapters from port A and hose. (15) Connect hose to port A. (16) Remove drain pan from under vehicle. (1) Place drain pan under vehicle. (2) Disconnect hose from port A of boom swing control valve in four way (upper) control valve assembly. (3) Connect hydraulic tester kit between hose and port A with test hoses and adapters. (4) Start engine (TM 9-2320-366-10-1). (5) Position PTO switch to on (TM 9-2320-366-10-1). (6) Increase engine RPM to 1250-1450 RPM (TM 9-2320-366-10-1). (7) Position MHC power switch to ON (TM 9-2320-366-10-1). (8) Operate swing control to the right (TM 9-2320-366-10-1). (9) Observe reading of 2-3 gpm (8-11 lpm), with low pressure. (a) If flow and pressure are low, replace control valve (in four way control valve assembly). (b) If pressure is high with no flow, replace cross relief valve. If fault not corrected, replace hydraulic orbit motor. WARNING Wear approved eye protection when performing pressure checks. Failure to comply may result in oil getting into eyes. If oil contacts eyes, seek medical attention immediately. Drop hydraulic pressure to zero before disconnecting any hydraulic hose, tube, or fitting. Failure to comply may result in injury to personnel. Fuel and oil are slippery and can cause falls. Wipe up spilled fuel or oil with rags. Failure to comply may result in injury to personnel.