TM-9-2320-366-34-1 MTV Direct Maintenance Manual M1083 Series - Volume 1 Download

Page 1238 of 1591

TM 9-2320-366-34-1 Change 2 2-1072.7/(2-1072.8 Blank) Test continued on page 2-1072.9. WARNING Wear approved eye protection when performing pressure checks. Failure to comply may result in oil getting into eyes. If oil contacts eyes, seek medical attention immediately. Prolonged contact with lubricating oil (MIL-L-21 04) may cause a skin rash. Skin and clothing that come in contact with lubricating oil should be thoroughly washed immediately. Saturated clothing should be removed immediately. Areas in which lubricating oil is used should be well ventilated to keep fumes to a minimum. Failure to comply may result in injury to personnel. Lubricating oil is slippery and can cause falls. Wipe up spilled oil with rags. Failure to comply may result in injury to personnel. Drop hydraulic pressure to zero before disconnecting any hydraulic line.Failure to comply may result in injury to personnel. Hydraulic components are hot when hydraulic oil reaches operating temperature. Use caution when handling hydraulic components. Wear gloves or use rags to hold metal objects. Failure to comply may result in injury to personnel. CAUTION NOTE PRESSURE TEST (1) Disconnect pressure test cable from pressure transducer. (2) Disconnect adapter and test hose from tee fitting. (3) Install cap on tee fitting at port A. (4) Remove cap from tee fitting on port B. (5) Install adapter and test hose on tee fitting at port B. (6) Connect pressure test cable to transducer and to Test Set. (7) Start engine (TM 9-2320-366-10-1) (8) Position PTO switch to on (TM 9 -2320-366-10-1). Keep tachometer within 1,250-1,450 RPM when PTO is engaged. Failure to comply may result in damage to equipment. In the event of a tachometer failure, a HAND THROTTLE lever positioned to L is approximately 1,250-1,450 RPM. (9) Set engine speed to 1250-1450 RPM (TM 9-2320-366-10-1).