TM-9-2320-366-34-1 MTV Direct Maintenance Manual M1083 Series - Volume 1 Download
Page 1226 of 1591
WARNING Dump body weighs approximately 3,030 lbs. (1,376 kgs). Attach a suitable lifting device prior to lifting. Failure to comply may result in injury to personnel. Wear approved eye protection when performing pressure checks. Failure to comply may result in oil getting into eyes. If oil contacts eyes, seek medical attention immediately. PRESSURE TEST NOTE Change 2 2-1069/(2-1070 Blank) Prolonged contact with lubricating oil (MIL-L-21 04) may cause a skin rash. Skin and clothing that come in contact with lubricating oil should be thoroughly washed immediately. Saturated clothing should be removed immediately. Areas in which lubricating oil is used should be well ventilated to keep fumes to a minimum. Failure to comply may result in injury to personnel. Drop hydraulic pressure to zero before disconnecting any hydraulic line.Failure to comply may result in injury to personnel. Lubricating oil is slippery and can cause falls. Wipe up spilled oil with rags. Failure to comply may result in injury to personnel. Test continued on page 2-1070.1. (1) Remove safety pin from two locking pins. (2) Remove two locking pins from dump body. (3) Install two dump body lifting brackets in slots in dump body. (4) Attach cargo sling to dump body lifting brackets. (5) Lift dump body. (6) Raise two maintenance legs on frame. (7) Lower dump body on maintenance legs. (8) Position drain pan under vehicle. (9) Remove cap from 90-degree fitting on port P of the four-way relief valve. Route test hose between frame and exit under vehicle. (10) Install adapter and test hose on 90-degree fitting. (11) Instal pressure transducer (0-10,000 PSI [0-68,965 kPa]) on test hose. (12) Connect pressure test cable to pressure transducer and to Test Set. (13) Start engine (TM 9-2320-366-10-1). (14) Position PTO switch to on (TM 9-2320-366-10-1). TM 9-2320-366-34-1