TM-9-2320-366-34-1 MTV Direct Maintenance Manual M1083 Series - Volume 1 Download
Page 1220 of 1591
TM 9-2320-366-34-1 TM 9-2320-366-34-1 TM 9-2320-366-34-1 TM 9-2320-366-34-1 TM 9-2320-366-34-1 MONOBLOCK VALVE FLOW TEST WARNING Wear approved eye protection when performing pressure checks. Failure to comply may result in oil getting into eyes. If oil contacts eyes, seek medical attention immediately. Drop hydraulic pressure to zero before disconnecting any hydraulic hose, tube, or fitting. Failure to comply may result in injury to personnel. Fuel and oil are slippery and can cause falls. Wipe up spilled fuel or oil with rags. Failure to comply may result in injury to personnel. Tag hydraulic hoses, tubes, and fittings prior to disconnecting. NOTE (1) Place drain pan under vehicle. (2) Disconnect hydraulic hose from input of monoblock valve assembly control valve. (3) Connect hydraulic tester between hose and fitting with hoses and adapters. (4) Start engine (TM 9-2320-366-10). (5) Position PTO switch to ON (TM 9-2320-366-10). (6) Observe flow of 12-14 gpm (45-53 lpm) at 2400-2950 psi (16548-20340 kPa). (7) If flow and pressure are not between 12-14 gpm (45-53 lpm) and 2400-2950 psi (16548-20340 kPa), replace hydraulic rotary pump (para 16-91). (8) Position PTO switch to OFF (TM 9- 2320-366-10 (9) Shutdown engine (TM 9-2320-366-10). (10) Disconnect flow/pressure kit and disassemble test equipment fittings and hoses from pressure flow kit, (11) Connect main valve tube to fitting. (12) Remove drain pan. 2-1063 2-1063 2-1063 2-1063 2-1063