TM-9-2320-366-34-1 MTV Direct Maintenance Manual M1083 Series - Volume 1 Download

Page 119 of 1591

TM 9-2320-366-34-1 2-2. SPECIAL TOOLS, TMDE, AND SUPPORT EQUIPMENT For a listing of special tools, TMDE, and support equipment, refer to the Maintenance Allocation Chart (MAC), (TM 9- 2320-366-20) and to the Repair Parts and Special Tools List (RPSTL), TM 9-2320-366-24P. 2-3. REPAIR PARTS Mandatory replacement parts are listed in Appendix F. Repair parts are listed and illustrated in the RPSTL, TM 9-2320- 366-24P, covering Unit, Direct Support and General Support repair parts and special tools for the vehicle. Section II. SERVICE UPON RECEIPT 2-4. UNPACKING AND DEPROCESSING a. Unpacking. Upon receipt of a new vehicle, the receiving organization must see if it has been properly prepared for service and is in good condition. Inspect all assemblies, subassemblies, and accessories to be sure they are in proper working order (TM 9-2320-366-10). Secure, clean, and correctly adjust and/or lubricate as needed (TM 9-2320- 366-20). Check all tools and equipment to be sure every item is accounted for (TM 9-2320-366-10-HR) in good condition, clean and properly mounted or stowed (TM 9-2320-366-10). b. Deprocessing. Read "Processing and Deprocessing Record of Shipping, Storage and Issue of Vehicles and Spare Engines" tag, (DD Form 1397) and follow all precautions checked. This tag should be attached to the steering wheel or manual throttle control lever. 2-5. HAND RECEIPT MANUAL AND INVENTORY OF EQUIPMENT When a new vehicle is first received by the using organization, it is necessary to inventory the vehicle equipment. For detailed procedures, refer to Hand Receipt Manual, TM 9-2320-366-10-HR. 2-6. SERVICE BEFORE OPERATION a. General. (1) Refer to TM 9-2320-366-10-1 for operating instructions for the vehicle. (2) Upon receipt of a new, used, or reconditioned vehicle, the receiving organization must see if it has been properly prepared for service and is in good condition (TM 9-2320-366-10). Inspect all assemblies, subassemblies, and accessories to be sure they are in proper working order. Secure, clean, correctly adjust, and/or lubricate (TM 9-2320- 366-10 and TM 9-2320-366-20) as needed. Check all tools and equipment to be sure every item is there (TM 9-2320- 366-10-HR), in good condition, clean and properly mounted or stowed (TM 9-2320-366-10). (3) Follow general procedures for all services and inspections given in TM 9-2320-366-10-1. b. Inspection and Servicing Equipment. NOTE If vehicle has been driven to the using organization, most or all of the following work should have been done. 2-2