TM-9-2320-366-34-1 MTV Direct Maintenance Manual M1083 Series - Volume 1 Download

Page 1182 of 1591

TM 9-2320-366-34-1 TM 9-2320-366-34-1 TM 9-2320-366-34-1 TM 9-2320-366-34-1 TM 9-2320-366-34-1 NOTE Tag all hardware prior to removal. HYDRAULIC FLOW AND PRESSURE TEST (14) Disconnect and disassemble STE/ICE-R, hoses and adapters. (15) Install plug in S1 port. (1) Place drain pan under vehicle. (2) Remove plug from port S1 (on side of self- recovery winch toward front of vehicle). (3) Connect STE/ICE-R (see test #50) to S1 port. (4) Start engine (TM 9-2320-366-10-1). (5) Attach stall load to winch cable (TM 9-2320-366-10-2). (6) Position PTO switch and WINCH POWER switch to ON (TM 9-2320-366-10-1). (7) Engage winch clutch (TM 9-2320-366-10-1). (8) Toggle WINCH IN/OUT switch to IN position and hold (TM 9-2320-366-10-1). (9) Perform STE/ICE-R test #50 and note reading. (10) If hydraulic pressure at port S1 is below 210 psi (618 kPa), counterbalance valve is faulty. (11) Release load and retrieve cable (TM 9-2320-366-10-2). (12) Position WINCH POWER and PTO switches to OFF (TM 9-2320-366-10-1). (13) Shut down engine (TM 9-2320-366-10-1). WARNING Wear approved eye protection when performing pressure checks. Failure to comply may result in oil getting into eyes. If oil contacts eyes, seek medical attention immediately. Fuel and oil are slippery and can cause falls. Wipe up spilled fuel or oil with rags. Failure to comply may result in injury to personnel. Drop hydraulic pressure to zero before disconnecting any hydraulic hose, tube, or fitting. Failure to comply may result in injury to personnel. 2-1025 2-1025 2-1025 2-1025 2-1025