TM-9-2320-366-34-1 MTV Direct Maintenance Manual M1083 Series - Volume 1 Download
Page 1150 of 1591
TM 9-2320-366-34-1 TM 9-2320-366-34-1 TM 9-2320-366-34-1 TM 9-2320-366-34-1 TM 9-2320-366-34-1 WARNING Wear approved eye protection when performing pressure checks. Failure to comply may result in oil getting into eyes. If oil contacts eyes, seek medical attention immediately. Fuel and oil are slippery and can cause falls. Wipe up spilled fuel or oil with rags. Failure to comply may result in injury to personnel. NOTE STINGER CYLINDER PRESSURE TEST (1) Place drain pan under vehicle. (2) Disconnect stinger OUT (RH) and stinger IN (LH) hoses at stinger cylinder (test points). (3) Connect hydraulic tester between stinger OUT (RH) hose and test point fitting with fittings and adapters. (4) Start engine (TM 9-2320-366-10-1). (5) Position PTO switch to on (TM 9-2320-366-10-1). (6) Increase engine RPM to 1250-1450 RPM (TM 9-2320-366-10-1). (7) Position STINGER control valve handle to OUT, perform pressure test and note pressure reading. (8) Position PTO switch to off (TM 9-2320-366-10-1). (9) Shut down engine (TM 9-2320-366-10-1). (10) Disconnect hydraulic tester fittings and adapters. (11) Connect stinger out (RH) hose to stinger test point fitting. (12) Disconnect stinger in (LH) hose from stinger test point fitting. (13) Connect hydraulic tester between stinger IN (LH) hose and test point fitting with fittings and adapters. (14) Start engine (TM 9-2320-366-10-1). (Continued on next page) Drop hydraulic pressure to zero before disconnecting any hydraulic hose, tube, or fitting. Failure to comply may result in injury to personnel. Tag hydraulic hoses, tubes, and fittings prior to disconnecting. 2-999 2-999 2-999 2-999 2-999