TM-9-2320-366-34-1 MTV Direct Maintenance Manual M1083 Series - Volume 1 Download

Page 1148 of 1591

TM 9-2320-366-34-1 TM 9-2320-366-34-1 TM 9-2320-366-34-1 TM 9-2320-366-34-1 TM 9-2320-366-34-1 2-997 2-997 2-997 2-997 2-997 WARNING Wear approved eye protection when performing pressure checks. Failure to comply may result in oil getting into eyes. If oil contacts eyes, seek medical attention immediately. Fuel and oil are slippery and can cause falls. Wipe up spilled fuel or oil with rags. Failure to comply may result in injury to personnel. CAUTION Exercise caution when operating stiffleg. Failure to comply may cause hoses to rub against stiffleg causing damage to equipment. UPPER MAIN CONTROL VALVE PRESSURE/FLOW TEST (CONT) (Continued from previous page) (14) Position PTO switch to OFF (TM 9-2320-366-10-1). (15) Shutdown engine (TM 9-2320-366-10-1). Drop hydraulic pressure to zero before disconnecting any hydraulic hose, tube, or fitting. Failure to comply may result in injury to personnel. (16) Disconnect hydraulic tester from hydraulic system: (a) Disconnect reservoir test hose from right stiffleg retract hose. (b) Disconnect pressure test hose from right stiffleg extend hose. (c) Disconnect test hoses from pressure and reservoir ports of hydraulic tester. (17) Connect retract hoses to retract port of right stiffleg cylinder. (18) Connect extend hose to extend port of right stiffleg cylinder. (19) Slide on cover over right stiffleg assembly and close lid on right hand rear storage box. (20) Remove drain pan from under vehicle.