TM-9-2320-366-20-5 MTV Unit Maintenance Manual M1083 Series - Volume 5 Download
Page 947 of 1158
E-9. RELAY TEST WIRE Fabricate the relay test wire according to the following steps. Refer to the following parts list for materials. Material Description National Stock Number Cut Length Wire, Electrical (MIL-W-16878) 6145-00-330-3318 6 in. (152 mm) a. Dimensions are in inches (millimeters). b. Cut a length of wire six inches (152 mm) long. c. Remove approximately 3/4 in. (19 mm) of electrical insulation from each end of wire. E-10. TRANSMISSION AUXILIARY OIL COOLER RUBBER SEAL Fabricate the transmission auxiliary oil cooler rubber seals in accordance with the following parts list. Part Number Description National Stock Number Cut Length inches mm MIL-R-6130 Tape, Adhesive, Rubber 9320-00-501-7537 24.7 627 E-11. WHEEL BEARING SHIM TOOL REST Fabricate the wheel bearing shim tool rest according to the following steps. Refer to the following parts list for materials. Part Number National Stock Number Description QQ-T-570 9510-00-866-1037 Bar, Metal a. Dimensions are in inches (millimeters) b. Cut metal bar to 9.0 inches (228.6 mm) long. c. De-burr and remove sharp edges from ends of metal bar. E-12. PNEUMATIC TUBES FABRICATION Cut pneumatic tubes from bulk tubing stock listed in Table E-1. Pneumatic Tube Lengths. Use a fine-toothed hacksaw or suitable cutting device and cut tubing to required length. Table E-1. Pneumatic Tube Lengths Tube Part Number Bulk Tubing Part Number Cut Length inches cm 12414690-001 NT-100-4 (79470) 18.1 46.0 12414690-002 NT-100-4 (79470) 16.0 40.6 12414690-003 NT-100-4 (79470) 15.0 38.1 12414690-004 NT-100-4 (79470) 74.8 190.0 12414690-005 NT-100-4 (79470) 69.7 177.0 E-17 E-17 TM 9-2320-366-20-5