TM-9-2320-366-20-5 MTV Unit Maintenance Manual M1083 Series - Volume 5 Download

Page 850 of 1158

TM 9-2320-366-20-5 23-9. M1090/M1094 TAILGATE PNEUMATIC CYLINDER REPLACEMENT This task covers: a. Removal b. Installation c. Follow-On Maintenance INITIAL SETUP Equipment Conditions Dump body raised to maintenance position (TM 9-2320-366-10-1). Engine shut down (TM 9-2320-366-10-1). Air tanks drained (TM 9-2320-366-10-1). Tools and Special Tools Tool Kit, Genl Mech (Item 46, Appendix C) Goggles, Industrial (Item 15, Appendix C) Material/Parts Dispenser, Pressure Sensitive Adhesive Tape (Item 20, Appendix D) Antiseize Compound (Item 13, Appendix D) WARNING Wear appropriate eye protection when working under vehicle due to the possibility of falling debris. Failure to comply may result in injury to personnel. a. Removal. NOTE Tag hoses and connection points prior to disconnecting. (1) Disconnect two hoses (1) from 90-degree fittings (2). WARNING Retaining rings are under tension and can act as projectiles when released causing severe eye injury. Use care when removing retaining rings. Failure to comply may result in injury to personnel. (2) Remove two retaining rings (3) and pivot pin (4) from tailgate pneumatic cylinder (5). (3) Remove cotter pin (6), pivot pin (7), and tailgate pneumatic cylinder (5) from dump body (8). 23-26