TM-9-2320-366-20-5 MTV Unit Maintenance Manual M1083 Series - Volume 5 Download
Page 503 of 1158
TM 9-2320-366-20-5 (6) Remove nut (13), lockwasher (14), washer (15), and terminal lugs TL1 (16) and TL166 (17) from terminal block terminal (18). Discard lockwasher. (7) Remove three screws (19), washers (20), clamps (21), and 200 amp alternator to terminal block 24 vdc cable (9) from engine (22). (8) Remove convoluted tubing (23) from 200 amp alternator to terminal block 24 vdc cable (9). b. Installation. NOTE Install plastic cable ties as required. (1) Install convoluted tubing (1) on 200 amp alternator to terminal block 24 vdc cable (2). (2) Position 200 amp alternator to terminal block 24 vdc cable (2) on engine (3) with three clamps (4), washers (5), and screws (6). (3) Tighten three screws (6) to 22-27 lb-ft (31-37 N·m). 20-287