TM-9-2320-366-20-5 MTV Unit Maintenance Manual M1083 Series - Volume 5 Download
Page 47 of 1158
TM 9-2320-366-20-5 Change 2 17-11 (4) Position cable (2) and wedge (3) in wedge socket (1). (5) Drive wedge (3) and cable loop up into wedge socket (1). (6) Install extra cable piece to dead end of cable as close to the wedge (3) as possible with two clamps, brackets, and nuts. (7) Install hook block (4) on the wedge socket (1) with washer (5), screw (6), washer (7), and nut (8). (8) Install cotter pin (9) in nut (8). NOTE The dead end of the cable should extend from the socket for a distance of 6 to 9 times the cable diameter. NOTE • The U-bolt part of the clamp should bear against the dead end of the cable and the saddle of the clamp should be against the short extra piece. • The dead end of the cable should never be clamped to the live end.