TM-9-2320-366-20-5 MTV Unit Maintenance Manual M1083 Series - Volume 5 Download
Page 46 of 1158
TM 9-2320-366-20-5 17-10 Change 2 17-4. M1084/M1086 HOOK BLOCK AND CABLE ASSEMBLY REPLACEMENT/REPAIR (CONT) (3) Install hook eye (8) on swivel hook (2) with self- locking nut (9). (4) Install hook eye (8) in hook block (10) with screw (11) and nut (12). (5) Install cotter pin (13) in nut (12). e. Installation. (1) Cut off a short length of cable 2-3 in. (51-76 mm) and set aside. (2) Place wedge socket (1) in vise. (3) Make a loop in the cable (2) and put free (dead) end of cable back through hole in wedge socket. WARNING Cable can become frayed or contain broken wires. Wear heavy leather-palmed gloves when handling cable. Frayed or broken wires can injure hands. Failure to comply may result in injury to personnel. NOTE • If the end of the cable is welded, the welded end should be cut off. This will allow the distortion of the cable strands, caused by the sharp bend around the wedge, to adjust themselves at the end of the line. • Make sure there are no rough edges on the wedge socket.