TM-9-2320-366-20-5 MTV Unit Maintenance Manual M1083 Series - Volume 5 Download
Page 373 of 1158
TM 9-2320-366-20-5 19-12. AIR TRANSPORTABILITY HYDRAULIC HOSE REPLACEMENT This task covers: a. Hydraulic Hose Locations b. Follow-On Maintenance INITIAL SETUP Equipment Conditions Engine shut down (TM 9-2320-366-10-1). Cab raised, if required (TM 9-2320-366-10-1). Spare tire lowered, if required (TM 9-2320-366-10-2). Manifold removed from tool box (para 19-4). Back-up hydraulic pump cover removed, if required. Decontamination unit mounting bracket removed, if required (para 19-3). Tools and Special Tools Tool Kit, General Mech (Item 46, Appendix C) Tools and Special Tools (Cont) Pan, Drain (Item 24, Appendix C) Goggles, Industrial (Item 15, Appendix C) Gloves, Rubber (Item 13, Appendix C) Materials/Parts Dispenser, Pressure Sensitive Adhesive Tape (Item 20, Appendix D) Cap and Plug Set (Item 14, Appendix D) Rag, Wiping (Item 50, Appendix D) Ties, Cable Plastic (Item 69, Appendix D) a. Hydraulic Hose Locations. WARNING • Wear appropriate eye protection when working under vehicle due to the possibility of falling debris. Failure to comply may result in injury to personnel. • Hydraulic fluid (MIL-H-5606) is TOXIC. Wear protective goggles and gloves; use only in well ventilated areas; avoid contact with skin, eyes, and clothes. Skin and clothing that come in contact with hydraulic oil should be washed immediately. Saturated clothing should be removed immediately. Failure to comply may result in injury to personnel. CAUTION Cap or plug hoses and connection points to prevent contamination of air transportability hydraulic system. Failure to comply may result in damage to equipment. NOTE • Refer to Table 19-3. Air Transportability Hydraulic Hose Locations for locations of hydraulic hoses on the air transportability hydraulic system. It may not be necessary to remove all hydraulic hoses at one time. • Tag hoses and connection points prior to removal. • Remove plastic cable ties as required. • Remove clamps and support brackets as required. • Position drain pan to collect hydraulic fluid. 19-61