TM-9-2320-366-20-5 MTV Unit Maintenance Manual M1083 Series - Volume 5 Download

Page 357 of 1158

TM 9-2320-366-20-5 19-9. EMERGENCY CAB LIFT PROCEDURE This task covers: a. Cab Lift b. Follow-On Maintenance INITIAL SETUP Equipment Conditions Engine shut down (TM 9-2320-366-10-1). Tools and Special Tools Tool Kit, Genl Mech (Item 46, Appendix C) Goggles, Industrial (Item 15, Appendix C) Gloves, Rubber (Item 13, Appendix C) Pan, Drain (Item 24, Appendix C) Cab Support Tool (Item E-4, Appendix E) Materials/Parts Cap and Plug Set (Item 14, Appendix D) Nut, Self-locking (4) (Item 168, Appendix G) Personnel Required (2) a. Cab Lift. CAUTION Perform this task in the event that the air/ hydraulic power unit and the back-up hydraulic pump are inoperative at the same time. (1) Place drain pan under hydraulic hose (1). WARNING Hydraulic fluid (MIL-H-5606) is TOXIC. Wear protective goggles and gloves; use only in well-ventilated area; avoid contact with skin, eyes, and clothes. Skin and clothing that come in contact with hydraulic oil should be washed immediately. Saturated clothing should be removed immediately. Failure to comply may result in injury to personnel. CAUTION Cap or plug hose and connection point to prevent contamination of hydraulic system. Failure to comply may result in damage to equipment. (2) Disconnect hydraulic hose (1) from 90-degree fitting (2). (3) Remove four self-locking nuts (3), washers (4), screws (5), from cab hydraulic latch (6) and cab support assembly (7). Discard self-locking nuts. 19-45