TM-9-2320-366-20-5 MTV Unit Maintenance Manual M1083 Series - Volume 5 Download
Page 344 of 1158
TM 9-2320-366-20-5 19-7. CAB HYDRAULIC LATCH REPLACEMENT/ADJUSTMENT This task covers: a. Removal b. Installation c. Adjustment d. Follow-On Maintenance INITIAL SETUP Equipment Conditions Engine shut down (TM 9-2320-366-10-1). Cab raised (TM 9-2320-366-10-1). Tools and Special Tools Tool Kit, Genl Mech (Item 46, Appendix C) Wrench, Torque, 0-175 lb-ft (Item 58, Appendix C) Pan, Drain (Item 24, Appendix C) Goggles, Industrial (Item 15, Appendix C) Gloves, Rubber (Item 13, Appendix C) Materials/Parts Cap and Plug Set (Item 14, Appendix D) Hydraulic Fluid A (Item 25, Appendix D) Nut, Self-Locking (4) (Item 168, Appendix G) a. Removal. (1) Position drain pan under hydraulic hose (1). WARNING Hydraulic fluid (MIL-H-5606) is TOXIC. Wear protective goggles and gloves; use only in well ventilated area; avoid contact with skin, eyes, and clothes. Skin and clothing that come in contact with hydraulic oil should be washed immediately. Saturated clothing should be removed immediately. Failure to comply may result in injury to personnel. CAUTION Cap or plug hydraulic hose and connection point to prevent contamination of hydraulic system. Failure to comply may result in damage to equipment. (2) Disconnect hydraulic hose (1) from 90-degree fitting (2). (3) Remove four self-locking nuts (3), washers (4), screws (5), and hydraulic latch (6) from cab support assembly (7). Discard self-locking nuts. (4) Remove 90-degree fitting (2) from hydraulic latch (6). 19-32 Change 1