TM-9-2320-366-20-5 MTV Unit Maintenance Manual M1083 Series - Volume 5 Download
Page 300 of 1158
TM 9-2320-366-20-5 19-3. AIR/HYDRAULIC POWER UNIT AND BRACKET REPLACEMENT/REPAIR (CONT) c. Air/Hydraulic Power Unit Cleaning/Inspection. WARNING • Dry Cleaning Solvent (P-D-680) is TOXIC and flammable. Wear protective goggles and gloves; use only in well-ventilated area; avoid contact with skin, eyes, and clothes, and do not breathe vapors. Keep away from heat or flame. Never smoke when using solvent; the flashpoint for Type I Dry Cleaning Solvent is 100° F (38° C) and for Type II is 130° F (50° C). Failure to comply may result in serious injury or death to personnel. • If personnel become dizzy while using cleaning solvent, immediately get fresh air and medical help. If dry cleaning solvent contacts skin or clothes, flush with cold water. If dry cleaning solvent contacts eyes, immediately flush eyes with water and get immediate medical attention. Failure to comply may result in serious injury or death to personnel. (1) Clean all metal parts and filter thoroughly with dry cleaning solvent. NOTE Replace any part that fails visual inspection. (2) Inspect all parts for visible cracks or damage. (3) Inspect filter for clogged or punctured screen. d. Air/Hydraulic Power Unit Assembly. WARNING Use care when installing retaining rings. Retaining rings are under tension and can act as projectiles when released. Failure to comply may result in injury to personnel. (1) Install performed packing (1) and retainer (2) in cylinder (3) with retaining ring (4). (2) Position cylinder (3) and washer (5) in pump (6). (3) Tighten cylinder (3) to 90-100 lb-ft (122-136 N·m). (4) Position preformed packing (7) on pump (6). 19-8.4 Change 1