TM-9-2320-366-20-5 MTV Unit Maintenance Manual M1083 Series - Volume 5 Download
Page 276 of 1158
TM 9-2320-366-20-5 18-10. HEATER FAN CONTROL SWITCH REPLACEMENT This task covers: a. Removal b. Installation c. Follow-On Maintenance INITIAL SETUP Equipment Conditions Batteries disconnected (para 7-57). CTIS ECU removed (para 12-6). Tools and Special Tools Tool Kit, Genl Mech (Item 46, Appendix C) Materials/Parts Dispenser, Pressure Sensitive Adhesive Tape (Item 20, Appendix D) Nut, Self-Locking (3) (vehicle serial numbers 0001 through 3696 equipped with original personnel heaters) (Item 177, Appendix G) a. Removal. (1) Loosen two setscrews (1) in heater fan control switch knob (2). (2) Remove heater fan control switch knob (2) from heater fan control switch (3). NOTE Perform steps (3) and (5) on vehicle serial numbers 0001 through 3696 equipped with original personnel heaters. (3) Loosen three self-locking nuts (4) on knobs (5, 6, and 7). (4) Remove knobs (5, 6, and 7) from HEAT control cable (8), VENT control cable (9), and DEFR control cable (10). (5) Remove three self-locking nuts (4) from HEAT control cable (8), VENT control cable (9), and DEFR control cable (10). Discard self-locking nuts. 18-60