TM-9-2320-366-20-5 MTV Unit Maintenance Manual M1083 Series - Volume 5 Download
Page 246 of 1158
TM 9-2320-366-20-5 18-9. PERSONNEL HEATER REPLACEMENT/REPAIR This task covers: a. Removal b. Disassembly c. Cleaning/Inspection d. Assembly e. Installation f. Follow-On Maintenance INITIAL SETUP Equipment Conditions CTIS ECU removed (para 12-6). Auxiliary panel removed, if equipped (para 7-8). Kick panel removed (para 16-3). Tools and Special Tools Pan, Drain (Item 24, Appendix C) Goggles, Industrial (Item 15, Appendix C) Gloves, Rubber (Item 13, Appendix C) Tool Kit, Genl Mech (Item 46, Appendix C) Wrench, Torque, 0-175 lb-ft (Item 58, Appendix C) Wrench, Torque, 0-200 lb-in. (Item 59, Appendix C) Socket Set, Socket Wrench (Item 36, Appendix C) Tool Kit, Blind Rivet (Item 44, Appendix C) Drill, Portable, Electric (Item 7, Appendix C) Drill Set, Twist (Item 6, Appendix C) Materials/Parts Dispenser, Pressure Sensitive Adhesive Tape (Item 20, Appendix D) Cap and Plug Set (Item 14, Appendix D) Ties, Cable, Plastic (Item 69, Appendix D) Strap, Push Mount (2) (Item 65.1, Appendix D) Materials/Parts (Cont) Antifreeze, Ethylene Glycol, Permanent (Item 12, Appendix D) Rivet, Blind (12) (Item 258, Appendix G) Gasket (Item 30, Appendix G) Gasket (Item 37, Appendix G) Seal (Item 265, Appendix G) Gasket (Item 32, Appendix G) Gasket (Item 38, Appendix G) Gasket (2) (Item 33, Appendix G) Gasket (Item 34, Appendix G) Gasket (Item 35, Appendix G) Rag, Wiping (Item 50, Appendix D) Solvent, Dry Cleaning (Item 65, Appendix D) Soap, Laundry (Item 63, Appendix D) Gasket (3) (Item 40, Appendix G) Gasket (Item 36, Appendix G) Plastic Strip (Item 240, Appendix G) Nut, Self-Locking (3) (Item 177, Appendix G) Nut, Self-Locking (3) (Vehicle serial numbers 0001 through 3696 equipped with original personnel heaters) (Item 177, Appendix G) Decal (Item 11, Appendix G) NOTE Perform steps (1) through (25) to remove personnel heater assembly for access. a. Removal. WARNING Wear appropriate eye protection when working under vehicle due to the possibility of falling debris. Failure to comply may result in injury to personnel. (1) Position drain pan under radiator drain cock (1). (2) Open radiator drain cock (1) and drain approximately 15- 20 qt (14-19 L) of coolant from radiator (2). (3) Close radiator drain cock (1). 18-30 Change 1