TM-9-2320-366-20-5 MTV Unit Maintenance Manual M1083 Series - Volume 5 Download
Page 197 of 1158
TM 9-2320-366-20-5 Change 2 17-151 17-31. M1089 STINGER CYLINDER REPLACEMENT This task covers: a. Removal b. Installation c. Follow-On Maintenance INITIAL SETUP Equipment Conditions Crossbar assembly removed (para 16-69). Stinger extended with outer end slightly higher than inner end (TM 9-2320-366-10-2). Engine shut down (TM 9-2320-366-10-1). Hydraulic reservoir supply and return valve closed (TM 9-2320-366-10-2). Tools and Special Tools Tool Kit, Genl Mech (Item 78, Appendix B) Goggles, Industrial (Item 28, Appendix B) Pan, Drain (Item 43, Appendix B) Wrench, Torque, 0-175 lb-ft (Item 92, Appendix B) Tools and Special Tools (Cont) Wrench Set, Crowfoot, Ratcheting (TM 9-2320-366-20) Materials/Parts Dispenser, Pressure Sensitive Adhesive Tape (Item 30, Appendix C) Solvent, Dry Cleaning (Item 83, Appendix C) Preformed Packing (2) (Item 234, Appendix F) Personnel Required (2) a. Removal. (1) Remove two retaining rings (1) from retaining pin (2). (2) Remove retaining pin (2) from inner tube (3). WARNING Use care when removing retaining rings. Retaining rings are under tension and can act as projectiles when released. Failure to comply may result in injury to personnel.