TM-9-2320-366-20-5 MTV Unit Maintenance Manual M1083 Series - Volume 5 Download
Page 160 of 1158
TM 9-2320-366-20-5 17-25. WINCH CONTROL VALVE ASSEMBLY AND BRACKET REPLACEMENT This task covers: a. Removal (All Models Except M1090/M1094) b. Installation (All Models Except M1090/M1094) c. Removal (M1090/M1094) d. Installation (M1090/M1094) e. Follow-On Maintenance INITIAL SETUP Equipment Conditions Dump body raised to maintenance position (M1090/M1094) (TM 9-2320-366-10-1). Engine shut down (TM 9-2320-366-10-1). Tools and Special Tools Goggles, Industrial (Item 15, Appendix C) Pan, Drain (Item 24, Appendix C) Tool Kit, Genl Mech (Item 46, Appendix C) Wrench, Torque, 0-175 lb-ft (Item 58, Appendix C) Socket Set, Socket Wrench (Item 34, Appendix C) Materials/Parts Dispenser, Pressure Sensitive Adhesive Tape (Item 20, Appendix D) Cap and Plug Set (Item 14, Appendix D) Ties, Cable, Plastic (Item 69, Appendix D) Oil, Lubricating, OE/HDO 10 (Item 42, Appendix D) Rag, Wiping (Item 50, Appendix D) Packing, Preformed (5) (Item 179, Appendix G) WARNING Wear appropriate eye protection when working under vehicle due to the possibility of falling debris. Failure to comply may result in injury to personnel. a. Removal (All Models Except M1090/M1094). CAUTION Cap or plug hoses and connection points to prevent contamination of hydraulic system. Failure to comply may result in damage to equipment. NOTE • Remove plastic cable ties as required. • Tag hoses and connection points prior to disconnecting. (1) Disconnect five hoses (1) from winch control valve (2). 17-114