TM-9-2320-366-20-5 MTV Unit Maintenance Manual M1083 Series - Volume 5 Download
Page 152 of 1158
TM 9-2320-366-20-5 17-110 Change 2 17-24. 15K SELF-RECOVERY WINCH (SRW) CABLE REPLACEMENT/REPAIR This task covers: a. Removal b. Spelter Socket Removal c. Spelter Socket Installation d. Installation e. Follow-On Maintenance INITIAL SETUP Equipment Conditions 15K SRW cable payed-out completely from front of vehicle (TM 9-2320-366-10-2). Engine shut down (TM 9-2320-366-10-1). Tools and Special Tools Tool Kit, Genl Mech (Item 46, Appendix C) Gloves, Welder's (Item 14, Appendix C) Goggles, Industrial (Item 15, Appendix C) Grease, Wire Rope-Exposed Gear (Item 23.1, Appendix D) Tools and Special Tools (Cont) Wire, Nonelectrical (Item 72, Appendix D) Tape, Duct (Item 67, Appendix D) Adhesive (Item 10.1 Appendix D) Spelter Socket Resin (Item 65.3, Appendix D) Vise, Machinist (Item 48,Appendix C) Frame, Hand Hacksaw (Item 9.1, Appendix C) Blade, Hand Hacksaw (Item 3.1, Appendix C) Personnel Required (3) a. Removal. (1) Remove cable wedge (1) and 15K SRW cable (2) from flange (3). (2) Pull 15K SRW cable (2) from flange (3). (3) Remove 15K SRW cable (2) from drum (4). WARNING • Wear leather gloves at all times when handling winch cable. Do not allow cable to slide through hands even with gloves on. Broken wires may cause injury. Failure to comply may result in injury to personnel. • Wear appropriate eye protection when working under vehicle due to the possibility of falling debris. Failure to comply may result in injury to personnel.