TM-9-2320-366-20-5 MTV Unit Maintenance Manual M1083 Series - Volume 5 Download
Page 115 of 1158
TM 9-2320-366-20-5 Change 2 17-77 17-18. M1089 30K WINCH CABLE REPLACEMENT/REPAIR This task covers: a. Removal b. Spelter Socket Removal c. Spelter Socket Installation d. Installation e. Adjustment f. Follow-On Maintenance INITIAL SETUP Equipment Conditions 30K winch cable fully extended (TM 9-2320-366-10-2). Engine shut down (TM 9-2320-366-10-1). 30K winch frame catwalk opened (TM 9-2320-366-10-2). Tools and Special Tools Tool Kit, Genl Mech (Item 46, Appendix C) Gloves, Welder's (Item 14, Appendix C) Grease, Wire Rope-Exposed Gear (Item 23.1, Appendix-D) Wire, Non-Electrical (Item 72, Appendix D) Tools and Special Tools (Cont) Tape, Duct (Item 67, Appendix-D) Adhesive (Item 10.1, Appendix-D) Spelter Socket Resin (Item 65.3, Appendix- D) Vice, Machinist (Item 48, Appendix-C) Frame, Hand Hacksaw (Item 9.1, Appendix- C) Blade, Hand Hacksaw (Item 3.1, Appendix- C) Solvent, Dry Cleaning (Item 65, Appendix-D) Personnel Required (3) a. Removal. (1) Loosen two screws (1) on cable restraining plate (2). (2) Remove 30K winch cable (3) from cable restraining plate (2). (3) Remove 30K winch cable (3) from drum (4). WARNING Cable can become frayed or contain broken wires. Wear heavy leather-palmed gloves when handling cables. Frayed or broken wires can injure hands. Failure to comply may result in injury to personnel. NOTE Left and right side 30K winch cables are removed the same way. Left side shown.