TM-9-2320-366-20-4 MTV Unit Maintenance Manual M1083 Series - Volume 4 Download

Page 991 of 1558

TM 9-2320-366-20-4 14-61 (6) Position fender (8) on platform (1) with two washers (9), insulation washers (10), screws (11), and self- locking nuts (12). (7) Position two screws (13) and self-locking nuts (14) in fender (8). (8) Tighten self-locking nuts (12 and 14) to 18-22 lb-ft (24-30 Nm). c. Platform Disassembly. (1) Remove three self-locking nuts (1), screws (2) and floor plate (3) from platform (4). Discard self-locking nuts. Table 14-1. M1088 Platform Attaching Hardware PLATE A B C D E F G H I J K NUMBER OF SELF- LOCKING NUTS 4 3 4 4 4 4 4 4 5 4 4 NUMBER OF SCREWS 4 3 4 4 4 4 4 4 5 4 4 NOTE Left and right side fenders are installed the same way. Right side shown. NOTE Number of fasteners will vary from floor plate to floor plate. Refer to Table 14-1, M1088 Platform Attaching Hardware for number of fasteners required. Floor plate B shown.