TM-9-2320-366-20-4 MTV Unit Maintenance Manual M1083 Series - Volume 4 Download
Page 912 of 1558
TM 9-2320-366-20-4 13-24 Change 2 13-7. POWER STEERING HOSES AND TUBE REPLACEMENT (CONT) (4) Position clamp (4) on suction hose (8). (5) Install suction hose (8) on power steering reservoir (9). (6) Engage as many clamp tabs (6) as possible in tab windows (7) allowing little or no play between clamp (4) and suction hose (8). (7) Tighten clamp (4) to 8-9 lb-in. (1 N•m). (8) Measure gap on clamp (4). CAUTION Clamp tongue must be started in clamp groove. Failure to comply may result in damage to equipment. NOTE Minimum allowable gap on clamp is 0.2 in. (0.5 cm). If gap is less than 0.2 in. (0.5 cm), remove and re-install clamp.