TM-9-2320-366-20-4 MTV Unit Maintenance Manual M1083 Series - Volume 4 Download
Page 899 of 1558
TM 9-2320-366-20-4 Change 2 13-11 13-6. STEERING COLUMN REPLACEMENT This task covers: a. Removal b. Installation c. Follow-On Maintenance INITIAL SETUP Equipment Conditions Engine shut down (TM 9-2320-366-10-1). Turn signal switch removed (para 7-26). Cab raised (TM 9-2320-366-10-1). Tools and Special Tools Tool Kit, Genl Mech (Item 46, Appendix C) Goggles, Industrial (Item 15, Appendix C) Wrench, Torque, 0-175 lb-ft (Item 58, Appendix C) Tools and Special Tools (Cont) Wrench, Torque, 0-200 lb-in. (Item 59, Appendix C) Wrench Set, Socket (Item 49, Appendix C) Gloves, Rubber (Item 13, Appendix C) Materials/Parts Sealing Compound (Item 55.2, Appendix D) Washer, Spring (2) (Item 292, Appendix G) Locknut (Item 68, Appendix G) Nut, Self-Locking (4) (Item 128, Appendix G) a. Removal. (1) Remove four self-locking nuts (1), eight washers (2), and four screws (3) from steering column assembly (4). Discard self-locking nuts. (2) Remove locknut (5) and bolt (6) from steering gear arm universal joint (7). Discard locknut. (3) Disconnect steering gear arm universal joint (7) from steering gear input shaft (8). (4) Lower cab (TM 9-2320-366-10-1).