TM-9-2320-366-20-4 MTV Unit Maintenance Manual M1083 Series - Volume 4 Download
Page 891 of 1558
TM 9-2320-366-20-4 c. Assembly. NOTE Use number of threads counted from disassembly. (1) Position socket assembly (1) on drag link (2) with same number of threads showing as in removal. (2) Tighten nut (3) on drag link clamp (4) to 139-171 lb-ft (188-232 N·m). d. Installation. CAUTION Drag link must be installed with adjustable threaded rod end toward rear of vehicle. Failure to comply may result in damage to equipment. (1) Install drag link (1) in steering knuckle arm (2). (2) Position slotted nut (3) on drag link (1). (3) Tighten slotted nut (3) to 139-171 lb-ft (188-232 N·m). NOTE If slots in slotted nut do not line up with cotter pin hole in drag link, tighten slotted nut until slots and cotter pin hole are aligned. (4) Install cotter pin (4) in drag link (1). Change 1 13-5