TM-9-2320-366-20-4 MTV Unit Maintenance Manual M1083 Series - Volume 4 Download
Page 656 of 1558
TM 9-2320-366-20-4 11-5. REAR BRAKE PLUNGER ASSEMBLY REPLACEMENT/REPAIR (CONT) c. Cleaning/Inspection. WARNING Dry Cleaning Solvent (P-D-680) is TOXIC and flammable. Wear protective goggles and gloves; use only in well ventilated area; avoid contact with skin, eyes, and clothes, and do not breathe vapors. Keep away from heat or flame. Never smoke when using solvent; the flashpoint for Type I Dry Cleaning Solvent is 100°F (38°C) and for Type II is 130°F (50°C). Failure to comply may result in serious injury or death to personnel. If personnel become dizzy while using Dry Cleaning Solvent, immediately get fresh air and medical help. If Dry Cleaning Solvent contacts skin or clothes, flush with cold water. If Dry Cleaning Solvent contacts eyes, immediately flush eyes with water and get immediate medical attention. Failure to comply may result in injury to personnel. (1) Clean all metal parts thoroughly with dry cleaning solvent. NOTE Replace plungers, sleeves, screws, springs, and pawls as a unit. (2) Inspect adjusting plunger (1), adjusting sleeve (2), and adjusting screw (3) for damage. (3) Inspect screw (4), spring (5), and adjusting pawl (6) for damage. (4) Inspect anchor plunger (7) and guide screw (8) for damage. (5) Inspect rollers (9) for freedom of movement, and pitting or cracks. (6) Inspect spring (10) for cracks, distortion, or corrosion. (7) Inspect rubber (11) for deterioration or damage. 11-26