TM-9-2320-366-20-4 MTV Unit Maintenance Manual M1083 Series - Volume 4 Download
Page 651 of 1558
TM 9-2320-366-20-4 Change 2 11-21 (4) Apply grease to inside surface of seal (3). (5) Seat seal (3) on adjusting screw (4). (6) Install adjusting screw (4) in adjusting sleeve (5). Back off 1/4 turn. (7) Apply film of grease on adjusting sleeve (5). (8) Install adjusting sleeve (5) in adjusting plunger (6). (9) Apply film of grease on adjusting plunger (6). (10) Perform steps (4) through (9) for other adjusting plunger assembly. e. Installation. (1) Install anchor plunger (1) in plunger housing (2). (2) Position lockwasher (3) and guide screw (4) in plunger housing (2). (3) Tighten guide screw (4) to 15-25 lb-ft (20-34 N•m). (4) Perform steps (1) through (3) on second anchor plunger. CAUTION CAUTION • Ensure adjusting sleeve is installed in adjusting plunger with large shouldered end up. Failure to comply will cause self- adjusting feature not to function. • Adjusting sleeve must bottom on shoulder in adjusting plunger. If adjusting screw is threaded too far into adjusting sleeve, adjusting screw will bottom in adjusting plunger and automatic adjustment will not function. NOTE Align keyway in anchor plunger with hole in plunger housing. Anchor plunger marked “L” is for left plunger housing. Anchor plunger marked “R” is for right plunger housing. Failure to comply may result in damage to equipment.