TM-9-2320-366-20-4 MTV Unit Maintenance Manual M1083 Series - Volume 4 Download
Page 642 of 1558
TM 9-2320-366-20-4 11-3. REAR BRAKE SHOES REPLACEMENT/ADJUSTMENT (CONT) c. Installation. (1) Turn two adjusting screws (1) in plunger housings (2) until they bottom. (2) Apply a thin film of grease to slots (3) in two anchor plungers (4), adjusting screws (1), and inside of two holddown clips (5). WARNING • Do not rely on automatic adjusters to take up excessive initial clearance. Tightening adjusting screws against plunger housings may result in failure of automatic adjusters to function properly. Failure to comply may result in damage to equipment. • Brake shoe ends stamped ADJUSTER are positioned on adjusting screws. Failure to comply may result in damage to equipment. (3) Loosen two adjusting screws (1) 1/2 turn or until slots (3) are aligned with brake shoes (6). (4) Install two brake shoes (6) in holddown clips (5) with ends seated in slots in adjusting screws (1) and anchor plungers (4). (5) Install two return springs (7) on brake shoes (6). 11-12 Change 1