TM-9-2320-366-20-4 MTV Unit Maintenance Manual M1083 Series - Volume 4 Download
Page 638 of 1558
TM 9-2320-366-20-4 11-2. FRONT BRAKE SHOES REPLACEMENT/ADJUSTMENT (CONT) CAUTION • Wheel drum clearance must be checked along centerline of brake shoe at scallop. Failure to comply may result in damage to equipment. • Record the number of clicks as adjusting screw is loosened. All adjustments on any wheel should be within six clicks of one another. If not, repeat procedure or examine for damage. Failure to comply may result in damage to equipment. (8) Back off brake adjusting screw (5) to obtain 0.020-0.040 in. (0.051-0.102 cm) clearance. (9) Repeat steps (6 through 8) for second brake adjusting screw. (10) Remove two screws (2), lockwashers (3), and brake adjusting tool supports from spider (4). Discard lockwashers. (11) Install two lockwashers (3) and screws (2) in spider (4). e. Follow-On Maintenance. (1) Install tire (TM 9-2320-366-10-2). (2) Start engine (TM 9-2320-366-10-1). (3) Road test vehicle and check for proper brake operation. (4) Shut down engine (TM 9-2320-366-10-1). End of Task. 11-8