TM-9-2320-366-20-4 MTV Unit Maintenance Manual M1083 Series - Volume 4 Download
Page 626 of 1558
TM 9-2320-366-20-4 10-26 Change 2 10-6. SPINDLE REPLACEMENT (CONT) (8) Remove retainer (13), thrust washer (14), sleeve (15), and felt seal (16) from spindle (11). Discard retainer. b. Cleaning/Inspection (1) Clean all metal parts with dry cleaning solvent and dry using compressed air prior to inspection. (2) Inspect spindle (1), sleeve (2), and thrust washer (3) for cracks, pitting or corrosion. WARNING NOTE Vehicles with greasable front drive flange do not have felt seal or retainer. • Dry cleaning solvent (P-D-680) is TOXIC and flammable. Wear protective goggles and gloves; use only in well ventilated area; avoid contact with skin, eyes, and clothes, and do not breathe vapors. Keep away from heat or flame. Never smoke when using solvent; the flash point for Type I dry cleaning solvent is 100 degrees F (38 degrees C) and for Type II is 130 degrees F (50 degrees C). Failure to comply may result in serious injury or death to personnel. • If personnel become dizzy while using cleaning solvent, immediately get fresh air and medical help. If solvent contacts skin or clothes, flush with cold water. If solvent contacts eyes, immediately flush eyes with water and get immediate medical attention. Failure to comply may result in injury to personnel. • Compressed air used for cleaning purposes will not exceed 30 psi (207 km/h). Use only with effective chip guarding and personal protective equipment (goggles/shield, gloves, etc.). Failure to comply may result in injury to personnel. NOTE Replace any part that fails visual inspection.