TM-9-2320-366-20-4 MTV Unit Maintenance Manual M1083 Series - Volume 4 Download
Page 623 of 1558
TM 9-2320-366-20-4 Change 2 10-23 10-6. SPINDLE REPLACEMENT This task covers: a. Removal b. Cleaning/Inspection c. Installation. d. Follow-On Maintenance INITIAL SETUP Equipment Conditions Engine shut down (TM 9-2320-366-10-1) Cab raised (TM 9-2320-366-10-1) Air tanks drained (TM 9-2320-366-10-1) Wheel and tire removed (TM 9-2320-366-10-1) Hub assembly drained (for front spindles only) (Appendix H) Differential spider assembly removed (para 10- 3) Wheel bearing/CTIS seal removed (para 10-2) Front brake shoes removed (for front spindles only) (para 11-2) Rear brake shoes removed (for intermediate and rear spindles only) (para 11-3) Front brake air chamber removed (for front spindles only) (para 11-7) Rear brake air chambers removed (for intermediate and rear spindles only) (para 11- 8) Tools and Special Tools Goggles, Industrial (Item 15, Appendix C) Jack, Hydraulic, Hand (Item 21, Appendix C) Tool Kit, Genl Mech (Item 46, Appendix C) Trestle, Motor Vehicle Maintenance (Item 47, Appendix C) Wrench Set, Socket (Item 49, Appendix C) Wrench, Torque, 0-175 lb-ft (Item 58, Appendix C) Materials/Parts Antiseize Compound (Item 13, Appendix D) Grease, Automotive and Artillery (GAA) (Item 22, Appendix D) Oil, Lubricating, Gear, 80W-90 (Item 40, Appendix D) Rag, Wiping (Item 50, Appendix D) Sealing Compound (Item 57, Appendix D) Solvent, Dry Cleaning (Item 65, Appendix D) Retainer (Item 242, Appendix G) Personnel Required (2) WARNING Wear appropriate eye protection when working under vehicle due to the possibility of falling debris. Failure to comply may result in injury to personnel. NOTE Front, intermediate, and rear spindles are removed the same way. Front left spindle shown.