TM-9-2320-366-20-4 MTV Unit Maintenance Manual M1083 Series - Volume 4 Download
Page 614 of 1558
TM 9-2320-366-20-4 10-3. DIFFERENTIAL SPIDER ASSEMBLY REPLACEMENT (CONT) b. Cleaning/Inspection. WARNING • Dry cleaning solvent (P-D-680) is TOXIC and flammable. Wear protective goggles and gloves; use only in well ventilated area; avoid contact with skin, eyes, and clothes, and do not breathe vapors. Keep away from heat or flame. Never smoke when using solvent; the flashpoint for Type I dry cleaning solvent is 100 degrees F (38 degrees C) and for Type II is 130 degrees F (50 degrees C). Failure to comply may result in serious injury or death to personnel. • If personnel become dizzy while using Dry Cleaning Solvent, immediately get fresh air and medical help. If Dry Cleaning Solvent contacts skin or clothes, flush with cold water. If solvent contacts eyes, immediately flush eyes with water and get immediate medical attention. Failure to comply may result in injury to personnel. • Compressed air used for cleaning purposes will not exceed 30 psi (207 km/h). Use only with effective chip guarding and personal protective equipment (goggles/shield, gloves, etc). Failure to comply may result in injury to personnel. NOTE Thoroughly clean all metal parts with dry cleaning solvent and dry using compressed air prior to inspection. (1) Inspect inner bevel side gear (1) and outer bevel side gear (2) for cracked or broken gear teeth, scoring, pitting, and corrosion. Replace inner and/or outer bevel side gear that fail inspection. 10-14 Change 1