TM-9-2320-366-20-4 MTV Unit Maintenance Manual M1083 Series - Volume 4 Download

Page 609 of 1558

TM 9-2320-366-20-4 (18) Install inner bevel side gear (15) on spindle (12). CAUTION If alignment pins on wheel bearing nut do not line up with alignment holes on inner bevel side gear, loosen wheel bearing nut until pins and holes are aligned. Do not loosen wheel bearing nut more than one spline tooth. Failure to comply will result in damage to equipment. (19) Align pins (16) on wheel bearing nut (14) with alignment holes in inner bevel side gear (15). (20) Remove inner bevel side gear (15) from spindle (12). NOTE • Record measurement taken in step (21). • Steps (21) through (24) are not required when packing wheel bearings for Preventive Maintenance Checks and Services (PMCS). (21) Measure depth from surface of wheel bearing nut (14) to face of wheel end hub (2). Change 1 10-9