TM-9-2320-366-20-4 MTV Unit Maintenance Manual M1083 Series - Volume 4 Download
Page 602 of 1558
TM 9-2320-366-20-4 Section II. MAINTENANCE PROCEDURES 10-2. WHEEL BEARING/CENTRAL TIRE INFLATION SYSTEM (CTIS) SEAL REPLACEMENT This task covers: a. Removal b. Cleaning/Inspection c. Installation d. Follow-On Maintenance INITIAL SETUP Equipment Conditions Wheel removed (TM 9-2320-366-10-2). Differential spider assembly removed (para 10-3). Tools and Special Tools Tool Kit, Genl Mech (Item 46, Appendix C) Gloves, Rubber (Item 13, Appendix C) Goggles, Industrial (Item 15, Appendix C) Trestle, Motor Vehicle Maintenance (Item 106, Appendix C) Jack, Hydraulic, Hand (Item 21, Appendix C) Wrench, Torque, 0-175 lb-ft (Item 58, Appendix C) Socket, Socket Wrench (Item 72, Appendix B) CTIS Seal Driver (Item 19, Appendix E) Wheel Hub Grease Seal Driver (Item 20, Appendix E) Tools and Special Tools (Cont) Wheel Bearing Shim Tool Rest (Item 11, Appendix E) Gage, Depth, Micrometer (Item 10, Appendix C) Materials/Parts Rag, Wiping (Item 50, Appendix D) Adhesive (Item 5, Appendix D) Tape, Duct (Item 67, Appendix D) Solvent, Dry Cleaning (Item 65, Appendix D) Grease, Automotive and Artillery (GAA) (Item 22, Appendix D) Seal Assembly, CTIS (2) (Item 266, Appendix G) Seal Assembly, Hub (Item 267, Appendix G) Personnel Required (2) a. Removal. WARNING Wheel drum weighs approximately 90 lbs (41 Kgs). Use the aid of an assistant to help remove wheel drum. Failure to comply may result in injury to personnel. NOTE Front, intermediate, and rear axle wheel bearings and CTIS seals are removed the same way. Left front axle shown. (1) Remove wheel drum (1) from wheel end hub (2). 10-2