TM-9-2320-366-20-4 MTV Unit Maintenance Manual M1083 Series - Volume 4 Download
Page 599 of 1558
TM 9-2320-366-20-4 9-3. DRIVE SHAFT HINGING INSPECTION This task covers: a. Inspection INITIAL SETUP Equipment Conditions Engine shut down (TM 9-2320-366-10-1). Tools and Special Tools Tool Kit, Genl Mech (Item 46, Appendix C) Indicator, Dial (Item 25.1, Appendix B) Tools and Special Tools (Cont) Base, Magnetic (Item 2.1, Appendix B) Goggles, Industrial (Item 15, Appendix C) Materials/Parts Rag, Wiping (Item 50, Appendix D) WARNING Wear appropriate eye protection when working under vehicle due to the possibility of falling debris. Failure to comply may result in injury to personnel. a. Inspection. (1) Place vehicle on level surface. (2) Clean slip yoke (1) and shaft (2) with a dry rag. (3) Mount dial indicator magnetic base (3) on bottom center of slip yoke (1). (4) Place dial indicator (4) 0.5 inches (12.7 mm) from slip yoke seal (5). (5) Push up on shaft (2) and adjust indicator (4) to zero. (6) Pull down on shaft (2) and observe hinging reading. (7) If reading is greater than 0.020 in. (0.508 mm), replace drive shaft assembly (para 9-2). (8) Remove dial indicator (3) from shaft (2). End of Task. All data on pages 9-6 through 9-8, Change 1 9-5/(9-6 Blank) including pages 9-7 and 9-8 deleted.