Sign up to sell your inventory with NSN Lookup

TM-9-2320-366-20-4 MTV Unit Maintenance Manual M1083 Series - Volume 4 Download

Page 596 of 1558

TM 9-2320-366-20-4 9-2.4 Change 2 9-2. DRIVE SHAFT AND UNIVERSAL JOINT REPLACEMENT/REPAIR (CONT) (3) Tighten four screws (5). (3.1) Tighten four screws (5) to 26-35 lb-ft (35-47 N•m). (3.2) Fould tabs on four screws (5). (4) Deleted (5) Apply lubrication to grease fittings (1). (6) Perform steps (1) through (5) on opposite end of drive shaft (3). CAUTION NOTE • Perform the following step on kits equipped with shearhead screws. • When correct torque is reached, bearing cap small screw hex head will break off. Grease must flow from all four seals. Failure to comply may result in damage to equipment. NOTE Perform the following two steps on bearing cups equipped with tabs.