TM-9-2320-366-20-4 MTV Unit Maintenance Manual M1083 Series - Volume 4 Download
Page 592 of 1558
TM 9-2320-366-20-4 9-2 Change 2 Section II. MAINTENANCE PROCEDURES 9-2. DRIVE SHAFT AND UNIVERSAL JOINT REPLACEMENT/REPAIR This task covers: a. Removal b. Disassembly c. Cleaning/Inspection d. Assembly e. Installation f. Follow-On Maintenance INITIAL SETUP Equipment Conditions Engine shut down (TM 9-2320-366-10-1). Tools and Special Tools Tool Kit, Genl Mech (Item 46, Appendix C) Wrench, Torque, 0-175 lb-ft (Item 58, Appendix C) Goggles, Industrial (Item 15, Appendix C) Hammer, Hand (Item 18, Appendix C) Materials/Parts Grease, Automotive and Artillery (GAA) (Item 22, Appendix D) Solvent, Dry Cleaning (Item 65, Appendix D) Rag, Wiping (Item 50, Appendix D) Spider, Universal Joint, Vehicular (Item 274.2, Appendix G) Seal, Shaft (Item 271.2, Appendix G) Screw, Cap (8 per drive shaft) (Item 260.1, Appendix G) Personnel Required (2) a. Removal. (1) Lift tabs from two bearing cups (1). (1.1) Remove four screws (2) and two bearing cups (1) from drive yoke (3). Discard screws. (2) Slide drive shaft (4) from side to side and separate universal joint (5) from drive yoke (3). (3) Perform steps (1) and (2) on opposite end of drive shaft (4). WARNING Wear appropriate eye protection when working under vehicle due to the possibility of falling debris. Failure to comply may result in injury to personnel. NOTE • All drive shafts are removed the same way. Front drive shaft shown. • There are two types of bearing cups, those with tabs and those without. Perform the following step on bearing cups with tabs.