TM-9-2320-366-20-4 MTV Unit Maintenance Manual M1083 Series - Volume 4 Download
Page 52 of 1558
TM 9-2320-366-20-4 7-81. FRONT INTERVEHICULAR 12 VDC (7 PIN) CABLE REPLACEMENT This task covers: a. Removal b. Installation INITIAL SETUP Equipment Conditions Batteries disconnected (para 7-57). Tools and Special Tools Goggles, Industrial (Item 15, Appendix C) Tool Kit, Genl Mech (Item 46, Appendix C) Materials/Parts Ties, Cable, Plastic (Item 69, Appendix D) Nut, Self-Locking (2) (Item 128, Appendix G) WARNING Wear appropriate eye protection when working under vehicle due to the possibility of falling debris. Failure to comply may result in injury to personnel. a. Removal. NOTE Remove plastic cable ties as required. (1) Disconnect connector J52 (1) from connector P52F (2). (2) Remove two self-locking nuts (3), four washers (4), two screws (5), and front intervehicular 12 vdc cable (6) from vehicle. Discard self-locking nuts. b. Installation. (1) Install front intervehicular 12 vdc cable (6) on vehicle with two screws (5), four washers (4), and two self- locking nuts (3). NOTE Install plastic cable ties as required. (2) Connect connector J52 (1) to connector P52F (2). End of Task. 7-376 Change 1