TM-9-2320-366-20-4 MTV Unit Maintenance Manual M1083 Series - Volume 4 Download
Page 519 of 1558
TM 9-2320-366-20-4 8-16. M1088/M1089 TRANSMISSION AUXILIARY OIL COOLER HOSE REPLACEMENT This task covers: a. Removal (S/N 0001-7167) b. Installation (S/N 0001-7161) c. Removal (S/N 7162 and higher) d. Installation (S/N 7162 and higher) e. Follow-On Maintenance INITIAL SETUP Equipment Conditions Batteries disconnected (para 7-57). Tools and Special Tools Goggles, Industrial (Item 15, Appendix C) Pan, Drain (Item 24, Appendix C) Tool Kit, Genl Mech (Item 46, Appendix C) Wrench, Torque, 0-200 lb-in. (Item 59, Appendix C) Socket Set, Socket Wrench (Item 34, Appendix C) Wrench, Torque, 0-175 lb-ft (Item 58, Appendix C) Crowfoot Attachment, Socket Wrench (Item 12.1, Appendix B) Materials/Parts Dispenser, Pressure Sensitive Adhesive Tape (Item 20, Appendix D) Cap and Plug Set (Item 14, Appendix D) Ties, Cable, Plastic (Item 69, Appendix D) Nut, Self-Locking (2) (Item 167, Appendix G) Nut, Self-Locking (2) (Item 154, Appendix G) Nut, Self-Locking (2) (Item 152, Appendix G) Washer, Spring (2) (Item 291, Appendix G) Packing, Preformed (2) (Item 178.1, Appendix G) Personnel Required (2) WARNING • Wear appropriate eye protection when working under vehicle due to the possibility of falling debris. Failure to comply may result in injury to personnel. • Ensure exhaust system is cool before performing maintenance. Failure to comply may result in injury to personnel. NOTE Vehicle serial numbers 0001-7161 may have transmission oil cooler tubes installed. Vehicle serial numbers 7162 and higher will have transmission oil cooler hoses installed. a. Removal (S/N 0001-7161). (1) Remove two self-locking nuts (1), washers (2), and screws (3) from heat shield (4). Discard self-locking nuts. (2) Remove two self-locking nuts (5), spring washers (6), washers (7), screws (8), washers (9), and heat shield (4) from transmission auxiliary oil cooler (10). Discard self- locking nuts and spring washers. Change 1 8-85