TM-9-2320-366-20-4 MTV Unit Maintenance Manual M1083 Series - Volume 4 Download
Page 504 of 1558
TM 9-2320-366-20-4 8-14. M1090/M1094 TRANSMISSION AUXILIARY OIL COOLER REPLACEMENT This task covers: a. Removal b. Installation c. Follow-On Maintenance INITIAL SETUP Equipment Conditions Dump body raised to maintenance position (TM 9- 2320-366-10-1). Batteries disconnected (para 7-57). Tools and Special Tools Goggles, Industrial (Item 15, Appendix C) Pan, Drain (Item 24, Appendix C) Tool Kit, Genl Mech (Item 46, Appendix C) Wrench, Torque, 0-175 lb-ft (Item 58, Appendix C) Wrench, Torque 0-200 lb-in.(Item 60, Appendix C) Socket Set, Socket Wrench (Item 34, Appendix C) Crowfoot Attachment, Socket Set (Item 12.1, Appendix B) Material/Parts Dispenser, Pressure Sensitive Adhesive Tape (Item 20, Appendix D) Cap and Plug Set (Item 14, Appendix D) Ties, Cable, Plastic (Item 69, Appendix D) Nut, Self-Locking (6) (Item 155, Appendix G) Nut, Self-Locking (12) (Item 154, Appendix G) Packing, Preformed (2) (Item 178.1, Appendix G) Packing, Preformed (4) (Item 179, Appendix G) Transmission Auxiliary Oil Cooler Rubber Seal (2) (Item E-10, Appendix E) Personnel Required (2) WARNING • Wear appropriate eye protection when working under vehicle due to the possibility of falling debris. Failure to comply may result in injury to personnel. • Ensure exhaust system is cool before preforming maintenance. Failure to comply may result in severe burns. a. Removal. NOTE Remove plastic cable ties as required. (1) Disconnect connector clamp (1) from connector P209 (2). (2) Disconnect connector P209 (2) from connector J209 (3). 8-74 Change 1