TM-9-2320-366-20-4 MTV Unit Maintenance Manual M1083 Series - Volume 4 Download
Page 48 of 1558
TM 9-2320-366-20-4 7-372 Change 2 7-80. ENGINE CONTROL CABLE ASSEMBLY REPLACEMENT (CONT) (10) Apply electrical tape to terminal lug TL110 (21). (10) Install dust boot (20) on engine control cable assembly (1). (11) Position terminal lug TL110 (21) on voltage regulator (22) with washer (23) and self-locking nut (24). (12) Tighten self-locking nut (24) to 25 lb-in. (3 N • m). (13) Position dust boot (20) on terminal lug TL110 (21). (14) Install dust boot (25) on engine control cable assembly (1). (15) Position terminal lug TL35 (26) on voltage regulator (22) with washer (27) and self-locking nut (28). (16) Tighten self-locking nut (28) to 25 lb-in. (3 N • m). (17) Position dust boot (25) on terminal lug TL35 (26). (18) Install terminal lug TL6 (29) in dust boot (30). (19) Position terminal lugs TL2 (31) and TL6 (29) on alternator (32) with insulation washer (33), washer (34), and self-locking nut (35). (20) Tighten self-locking nut (35) to 40 lb-in. (5 N • m). (21) Position dust boot (30) on terminal lugs TL6 (29) and TL2 (31). (22) Position terminal lugs TL8 (36) and TL5 (37) on alternator (32) with washer (38), lockwasher (39), and screw (40). (23) Tighten screw (40) to 40 lb-in. (5 N • m). CAUTION Insulation washer must be installed with flat side up. Failure to comply may result in damage to equipment. NOTE • Perform step (10) if replacing alternator P/N N1506-1 (12420852) with alternator P/N 1509-1 (12422863). • Install plastic cable ties to TL110 and tie wrap wire away from alternator. NOTE Perform steps (10.1) through (13) on alternator P/N N1506-1 (12420852).