TM-9-2320-366-20-4 MTV Unit Maintenance Manual M1083 Series - Volume 4 Download
Page 461 of 1558
TM 9-2320-366-20-4 Change 2 8-37 NOTE (3) Position gasket (4) and transmission oil filter cover (2) on transmission control module (5) with six screws (6). NOTE (4) Position transmission oil filter cover (2) on trans-mission control module (5) with six screws (6). (5) Tighten six screws (6) to 38-45 lb-ft (52-61 N•m) in sequence shown. (6) Position universal joint (7) in drive yoke (8) with two bearing cups (9) and four screws (10). (7) Tighten four screws (10) to 26-35 lb-ft (35-47 N•m). (7.1) Fold down tabs on bearing cups (9). (7.2) Tighten four screws (10) to 26-35 lb-ft (35-47 N•m). CAUTION Perform step (3) on transmissions SN 6510069120 and higher. Perform step (4) on transmissions SN lower than 6510069120 Ensure needle bearings are aligned prior to installation of bearing cups on universal joint trunnions. Failure to comply may result in damage to equipment. NOTE When correct torque is reached, bearing cap screw small hex head will break off. NOTE Perform step (7.1) on bearing cups equipped with tabs.