TM-9-2320-366-20-4 MTV Unit Maintenance Manual M1083 Series - Volume 4 Download
Page 414 of 1558
TM 9-2320-366-20-4 7-744 Change 2 7-146. DUMP SWITCH BRACKET AND JUMPER CABLE REPLACEMENT This task covers: a. Removal b. Installation c. Follow-On Maintenance INITIAL SETUP Equipment Conditions Batteries disconnected (para 7-57). Tools and Special Tools Tool Kit, Genl Mech (Item 46, Appendix C) Wrench, Torque, 0-200 lb-in. (Item 59, Appendix C) Materials/Parts Dispenser, Pressure Sensitive Adhesive Tape (Item 20, Appendix D) Personnel Required (2) a. Removal. (1) Remove two screws (1) and washers (2) from dump switch bracket (3). (2) Lift dump switch bracket (3) outward from instrument panel (4) to gain access. (3) Lift tab (5) on connector P911 (6). (4) Disconnect connector P911 (6) from DUMP BED UP/DOWN switch (7). (5) Disconnect connector P911A (8) from DUMP BED UP/DOWN switch (7). NOTE • Tag electrical connectors and connection points prior to removal. • All rocker switches are removed the same way. DUMP BED UP/DOWN switch shown.