TM-9-2320-366-20-4 MTV Unit Maintenance Manual M1083 Series - Volume 4 Download
Page 373 of 1558
TM 9-2320-366-20-4 7-142. M1089 WINCH CONTROL WIRING HARNESS REPLACEMENT This task covers: a. Removal b. Installation c. Follow-On Maintenance INITIAL SETUP Equipment Conditions Engine shut down (TM 9-2320-366-10-1). Batteries disconnected (para 7-57). Tools and Special Tools Tool Kit, Genl Mech (Item 46, Appendix C) Tool Kit, Electrical (Item 45, Appendix C) Material/Parts Dispenser, Pressure Sensitive Adhesive Tape (Item 20, Appendix D) Lockwasher (8) (Item 100, Appendix G) Nut, Self-Locking (2) (Item 133, Appendix G) Splice, Conductor (8) (Item 274.3, Appendix G) Ties, Plastic, Cable (Item 69, Appendix D) Tape, Insulation, Electrical (Item 68, Appendix D) a. Removal. (1) Remove eight screws (1), lockwashers (2), and washers (3) from control panel top cover (4). Discard lockwashers. (2) Remove two self-locking nuts (5), four washers (6), two screws (7), and control panel top cover (4) from WRECKER CONTROL PANEL (8). Discard self-locking nuts. (3) Open LH catwalk (9) and RH catwalk (10) on 30K winch assembly (11). Change 1 7-703