TM-9-2320-366-20-4 MTV Unit Maintenance Manual M1083 Series - Volume 4 Download
Page 318 of 1558
TM 9-2320-366-20-4 7-132. START AND CHARGING CABLE ASSEMBLY REPLACEMENT (CONT) NOTE • All five clamps are removed the same way. One shown. • Step (37) requires the aid of an assistant. (37) Remove self-locking nut (84), screw (85), and clamp (86) from frame rail (87). Discard self-locking nut. (38) Remove start and charging cable assembly (8) from clamp (86). (39) Perform steps (37) and (38) on remaining four clamps. (40) Remove start and charging cable assembly (8) from vehicle. b. Installation. NOTE Install plastic cable ties as required. (1) Position start and charging cable assembly (1) on vehicle. NOTE All five clamps are installed the same way. One shown. (2) Position start and charging cable assembly (1) in clamp (2). NOTE Steps (3) and (4) require the aid of an assistant. (3) Position clamp (2) on frame rail (3) with screw (4) and self-locking nut (5). (4) Tighten self-locking nut (5) to 120-144 lb-in. (14-16 N·m). (5) Perform steps (2) through (4) on remaining four clamps. 7-650 Change 1