TM-9-2320-366-20-4 MTV Unit Maintenance Manual M1083 Series - Volume 4 Download
Page 250 of 1558
TM 9-2320-366-20-4 7-117. M1089 REMOTE CONTROL WIRING HARNESS REPLACEMENT This task covers: a. Removal b. Installation c. Follow-On Maintenance INITIAL SETUP Equipment Conditions Engine shut down (TM 9-2320-366-10-1). Batteries disconnected (para 7-57). Tools and Special Tools Tool Kit, Genl Mech (Item 46, Appendix B) Materials/Parts Dispenser, Pressure Sensitive Adhesive Tape (Item 20, Appendix D) Ties, Cable Plastic (Item 69, Appendix D) Lockwasher (8) (Item 100, Appendix G) Nut, Self-Locking (2) (Item 133, Appendix G) a. Removal. (1) Remove eight screws (1), lockwashers (2), and washers (3) from control panel top cover (4). Discard lockwashers. (2) Remove two self-locking nuts (5), four washers (6), two screws (7), and control panel top cover (4) from control panel (8). Discard self-locking nuts. NOTE • Tag electrical wires and connection points prior to disconnecting. • Remove plastic cable ties as required. (3) Loosen 17 screws (9) on terminal board (10) at positions 2, 3, 4, 6, 7a, 8, 9, and 10 through 19. (4) Remove 17 electrical wires (11) on terminal board (10) from positions 2, 3, 4, 6, 7a, 8, 9, and 10 through 19. 7-582