TM-9-2320-366-20-4 MTV Unit Maintenance Manual M1083 Series - Volume 4 Download
Page 1270 of 1558
TM 9-2320-366-20-4 16-198 Change 2 16-27. ROOF HATCH REPLACEMENT (ALL MODELS EXCEPT M1093/M1094) (CONT) b. Installation. (1) Install inside rubber strip (1) on roof hatch (2). (2) Install outside rubber strip (3) on roof hatch (2). (3) Install 6 in. (15.2 cm) back-up rubber strips (4) centered on joints of inside and outside rubber strips (1 and 3). (4) Position roof hatch (2) on cab roof (5) with matchmarks aligned. (5) Position 12 washers (6) and screws (7) in roof hatch (2). (6) Tighten 12 screws (7) to 35-41 lb-ft (48-56 N•m). (7) Apply 0.625 in. (1.5 cm) bead of sealing compound to 12 screws (6) and between roof hatch (2) and cab roof (5). End of Task. CAUTION WARNING Begin inside and outside rubber strip installation on opposite sides of each other. Failure to comply may result in damage to equipment. Adhesives, solvents, and sealing compounds can burn easily, can give off harmful vapors, and are harmful to skin and clothing. Keep away from open fire and use in a well-ventilated area. If adhesive, solvent, or sealing compound gets on skin or clothing, wash immediately with soap and water. Failure to comply may result in injury to personnel.